Select a vehicle from the "Settings tab" in "Manager Classic" and select "Hours Start:" in "Start" displayed in "EDIT" for what purpose?
Is the usage different from "Verify"?
Manager Classic
Best answer by Daniel B
Hello SAK,
In the beginning I was entering the hours in “Verify”. I ended up having problems with total hours.
Setting the “start hours” in “Classic” is what you should do.
Trackunit connected to CAN bus:
Some machines will give the hours from the CAN bus (engine ECU). Those will be set automatically after a few minutes of running. The machine display might not show the same hours. You might have to adjust. For example, I have a machine that had a 6 h difference between the CAN bus (ECU) and the display. To have Trackunit show the same hours on display, I had to enter -6 hours in Classic / settings / edit / hours start.
Trackunit NO CAN bus:
Some machines won’t have CAN bus, so hours will show on a digital display or on an hour meter. For those, you have to set the hours through Classic / settings / edit / hours start, so they match the machine.
I hope this can help.
Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.